1. Stow the mower.
Time to learn about fuel stabilizer. If your mower sits for months with gas in its tank, the gas will slowly deteriorate and can damage internal engine parts. You should add stabilizer to your gas can to keep spare gas in good condition over the winter, and top off your mower tank with stabilized gas before you put it away for the winter. Run the mower for five minutes to make sure the stabilizer reaches the carburetor.
Another lawn mower care method is to run your mower dry before stowing it.
1. When the mower is cool, remove the spark plug and pour a capful of engine oil into the spark plug hole.
2. Pull the starter cord a couple of times to distribute the oil, which keeps pistons lubricated and ensures an easy start come spring.
3. Turn the mower on its side and clean out accumulated grass and gunk from the mower deck.
2. Donâ€™t be a drip.
The last thing you want is a plumbing freeze up! Remove garden hoses from outdoor faucets - leaving hoses attached can cause water to back up in the faucets and in the plumbing pipes just inside your exterior walls. If freezing temps hit, that water could freeze, expand, and crack the faucet or pipes. Make this an early fall priority so a sudden cold snap doesnâ€™t sneak up and cause damage.
Turn off any shutoff valves on water supply lines that lead to exterior faucets. That way, youâ€™ll guard against minor leaks that may let water enter the faucet. While youâ€™re at it, drain garden hoses and store them in a shed or garage.
3. Time for your sprinkler system to go to sleep.
Time to drain your irrigation system. Even buried irrigation lines can freeze, leading to busted pipes and broken sprinkler head.
2. Shut off the automatic controller.
3. Open drain valves to remove water from the system.
4. Remove any above-ground sprinkler heads and shake the water out of them, then replace.
If you donâ€™t have drain valves, then hire an irrigation pro to blow out the systems pipes with compressed air. A pro is worth the charge to make sure the job is done right, and to ensure you donâ€™t have busted pipes and sprinkler head repairs to make in the spring.
4. Seal the deal.
Grab a couple of tubes of color-matched exterior caulk and make a journey around your homeâ€™s exterior, sealing up cracks between trim and siding, around window and door frames, and where pipes and wires enter your house. Preventing moisture from getting inside your walls is one of the least expensive - and most important - of your fall maintenance jobs. Youâ€™ll also seal air leaks that waste energy.
Pick a nice day when temps are above 50 degrees so caulk flows easily, (it's like piping decorative writing onto a cake).
5. Are your gutters clear?
Clogged rain gutters can cause ice dams, which can lead to expensive repairs. After the leaves have fallen, clean your gutters to remove leaves, twigs, and gunk. Make sure gutters arenâ€™t sagging and trapping water; tighten gutter hangers and downspout brackets. Replace any worn or damaged gutters and downspouts. You may even want to consider heaters especially made for gutters (or roofs). These are especially helpful if you are western facing where there is ice melting during the afternoon that runs into the gutters and then immediately refreezes when the sun goes down (that's from personal experience!)
If you find colored grit from asphalt roof shingles in your gutters, beware. That sand-like grit helps protect shingles from the damaging ultraviolet rays of the sun. Look closely for other signs of roof damage (#6, below); it may be time for a roofing replacement.
Your downspouts should extend at least 5 feet away from your house to prevent foundation problems. If they donâ€™t, add downspout extensions. 6. Eyeball your roof.
If you have a steep roof or a multi-story house, stay safe and use binoculars to inspect your roof from the ground.
Look for warning signs: Shingles that are buckled, cracked, or missing; rust spots on flashing. Any loose, damaged, or missing shingles should be replaced immediately.
Black algae stains are just cosmetic, but masses of moss and lichen could signal roofing thatâ€™s decayed underneath.
A plumbing vent stack usually is flashed with a rubber collar - called a boot - that may crack or loosen over time. Theyâ€™ll wear out before your roof does, so make sure theyâ€™re in good shape. A pro roofer will replace a boot, depending on how steep your roof is.
7. Direct your drainage.
Take a close look at the soil around your foundation and make sure it slopes away from your house at least 6 vertical inches over 10 feet. That way, youâ€™ll keep water from soaking the soils around your foundation, which could lead to cracks and leaks or creating slippery walking areas.
Be sure soil doesnâ€™t touch your siding.
8. Tune 'er up!
Schedule an appointment with a heating and cooling pro to get your heating system checked and tuned up for the coming heating season.
An annual maintenance contract ensures youâ€™re at the top of the list for checks and shaves 20% off the cost of a single visit. You should know that most maintenace & service contracts do not include plumbing work to the boiler.
Change your furnace filters on hot air furnaces. This is a job you should do every two months anyway, but if you havenâ€™t, nowâ€™s the time. If your HVAC includes a built-in humidifier, make sure the contractor replaces that filter.
9. Time for a trim.
Very late fall is the best time to prune plants and trees - when the summer growth cycle is over. Your goal is to keep limbs and branches at least 3 feet from your house so moisture wonâ€™t drip onto roofing and siding, and to prevent damage to your house exterior during high winds.
To make sure your fireplace is safe, grab a flashlight and look up inside your fireplace flue to make sure the damper opens and closes properly. Open the damper and look up into the flue to make sure itâ€™s free of birdsâ€™ nests, branches and leaves, or other obstructions. You should see daylight at the top of the chimney.
Check the firebox for cracked or missing bricks and mortar. If you spot any damage, order a professional fireplace and chimney inspection.
Your fireplace flue should be cleaned of creosote buildup every other year.
Feel free to contact me with questions